Connectors & Jumpers

The Samsung EcoGreen F2 is only available with a Serial ATA interface. It comes with native support for SATA 3Gb/s but can revert to the slower SATA 1.5Gb/s if the SATA controller cannot support the faster interface.

Like all Serial ATA drives, it comes the standard SATA data (left) and power (right) connectors and is hot-pluggable. That means you can connect this hard disk drive to your PC or disconnect it while the PC's running.

To the left side of these SATA connectors is the jumper block. Generally, you do not need to mess around with the jumper block. In fact, Samsung did not even provide a jumper with the drive. It's really meant for OEM manufacturers to tweak the drive for a particular build. For those who are interested, here is the only documented use for the Samsung EcoGreen F2's jumper block.

Generally, most SATA 1.5GB/s controllers will have no problem interfacing with SATA 3Gb/s devices like the Samsung EcoGreen F2. In some rare cases though, they may not be able to connect properly. You will need to force the Samsung EcoGreen F2 to use the SATA 1.5Gb/s interface protocol by inserting a jumper in the position shown above.

The Breather Hole

The Samsung EcoGreen F2 hard disk drive has a single breather hole on the top plate. You can see it in the picture on the left. There may be other breather holes elsewhere on the hard disk drive though.

The breather hole allows condensation inside the hard drive to escape. It also equalizes the hard drive's internal pressure with the ambient pressure. The hard drive needs it to function properly, so please make sure you do not occlude the hole!

Support Tech ARP!

If you like our work, you can help support out work by visiting our sponsors, participate in the Tech ARP Forums, or even donate to our fund. Any help you can render is greatly appreciated!